How to Properly Plant Your Shrubs

shrubbery When planting shrubs, experts advise you only dig the hole as deep as the root ball, but at least two times wider. This keeps the tree or shrub from sinking as the soil settles while allowing the feeder roots to grow out into the looser and generally more fertile top-soil.


Soil amendments are also discouraged since most tree roots have a natural spreading tendency and need to acclimate to indigenous soils as quickly as possible. Or, if you dig this nice wonderful ‘bowl’ newly growing roots tend to stay right there, circling around and around, not venturing out into the soil that isn’t so great. And if your soil is hard clay you will need to dig up a larger area than two times larger than the root ball.


Place your tree or shrub into the hole. Add some soil to support the tree while you check all the way around to make sure it is standing up straight and is facing the direction you desire. The top of the root ball should be at or above the soil level. If the root ball is too low you can possibly add soil to the bottom of the hole with your shovel, moving the root ball from side to side to get soil underneath.


If the root ball has burlap or a wire cage remove at least the top half being careful not to cause the ball to fall apart. Burlap under the ball will rot. Fill the hole in with soil halfway. Make any further adjustments. Water the soil to fill in any air pockets and help settle the soil. Fill in the remainder of the hole. Water the soil thoroughly with a slow stream of water. Finally,. mulch the area around the tree with a few inches of mulch without allowing to touch the trunk. Watch Grow!

Leave a reply